In the Requirements Chapter of this install document you downloaded a zip file that contains the i2b2 Workbench code. Unlike the source code for the cells, the zip file for the i2b2 Workbench contains an executable file that will run the workbench. Also included are the files needed by the workbench to run. The source code for the i2b2 Workbench is not included in the zip files we will be extracting in this chapter.
1. Set up a target source directory for the contents of the workbench zip file.
2. Locate the file you downloaded in the i2b2 Requirements Section.
3. Extract the files into the target source directory you just created.
You will want to make note of the location as it will be needed further along in the i2b2 installation. In the installation document whenever you see YOUR_I2B2_WB_DIR it will need to be replaced with the location of your i2b2 Weorkbench code.
For your convenience an installation Worksheet to track the setup locations has been provided in the Appendices Chapter.